51 43 251 Removing And Installing / Replacing Trim For Rear Left Or Right Roof Pillar (Rear)

WARNING:

Version with head airbag:

FOLLOW safety instructions for working on cars with airbag systems.

IMPORTANT:

Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Version with head airbag in rear compartment:

If necessary, lever out airbag emblem (1) and release screw underneath.

Tightening torque: 51 43 1AZ . See SIDE TRIM PANEL WITH ARMRESTS for specs.

Release clips (2) and catches (4) from trim (3).

Pull out trim (3) towards inside at top.

Fig 1: Pulling Out Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace defective grommets (1).

Fig 2: Identifying Grommets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retainer (1) on trim (2) must not be damaged or missing.

Fig 3: Identifying Retainer On Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clips (1) of panel (3).

Catches (2) on trim (3) must not be damaged.

Fig 4: Identifying Catches On Trim

Courtesy of BMW OF NORTH AMERICA, INC.