51 43 230 Removing And Installing / Replacing Trim On C-Pillar At Bottom Left Or Right
Special tools required:
Necessary preliminary tasks:
- Remove rear ENTRANCE COVER STRIP
- Remove REAR TRIM (C-PILLAR)
Version without electric rear seat adjustment only:
- Remove REAR SEAT BACK
Version with electric rear seat adjustment only:
Partially detach mucket (1).
Release screw (2).
Detach side trim (3) in direction of arrow from retainers (4).
Unclipping side trim (1):
- Carefully insert special tool 00 9 317 between decorative strip (2) and side trim (1)
- Carefully press special tool to middle
- Carefully pull off side trim (1) towards front
- If necessary, disconnect plug connection for C-pillar trim
Installation:
Feed in pin (1) of side trim under oddments tray (2).
Make sure catch (3) is correctly engaged on decorative strip (4).
Feed out seat belt and remove trim.