51 24 660 Correcting Fluid Level In Hydraulic Unit (From 02/2003) For Rear Lid Actuation (Electrohydraulic-Fully Automatic)

IMPORTANT:

Do not under any circumstance remove fluid tank from hydraulic unit.

Use fluid from "Small parts for hydraulic unit" set.

Follow NOTES AND INSTRUCTIONS for automatic rear lid actuation (electrohydraulic-fully automatic).

Necessary preliminary tasks:

NOTE:

Hoses on hydraulic unit must not be detached.

Have a cleaning cloth and an oil drip tray ready to catch emerging fluid.

Move hydraulic unit (1) into vertical position.

Release screw (2).

Tightening torque: 51 24 2AZ . See REAR LID LOCKS for specs.

Top up hydraulic fluid through opening.

Installation:

Replace sealing ring.

Fig 1: Identifying Hydraulic Unit

Courtesy of BMW OF NORTH AMERICA, INC.

When ideal filling is achieved:

Install hydraulic unit.

Close rear lid (motor-driven) twice and open again, this bleeds the system.

When rear lid is fully opened (cylinder retracted), fluid level (2) must be in area (A) of marking (3).

Fig 2: Identifying Fluid Level

Courtesy of BMW OF NORTH AMERICA, INC.