51 23 211 Removing And Installing/Replacing Cable For Front Engine Hood Locks (To Passenger Compartment)

Necessary preliminary tasks:

Lever connecting element (1) out of side panel (2).

Fig 1: Identifying Connecting Element And Side Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Open connecting element (1) and disengage Bowden cable (2).

NOTE: The scope of work "Disconnecting Bowden cable at connection point" ends here.

Fig 2: Identifying Connecting Element And Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove fixture (2) and feed out Bowden cable (3).

Fig 3: Identifying Fixture And Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Feed Bowden cable (1) out of grommet (2).

Carefully feed Bowden cable (1) with grommet (3) out of vehicle interior.

IMPORTANT:

Make sure grommets (2 and 3) are correctly seated (water ingress).

Installation:

Lay Bowden cable (1) without kinks.

Fig 4: Identifying Bowden Cable And Grommets

Courtesy of BMW OF NORTH AMERICA, INC.