51 13 115 Removing And Installing / Replacing Cowl Panel Cover

Necessary preliminary tasks:

Pull off rubber seal (1).

Fig 1: Identifying Rubber Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off corners of cover from windscreen (1).

If necessary, release locks on cover (2).

Installation:

If necessary, remove butyl remnants from windscreen (1).

Fig 2: Pulling Off Corners Of Cover From Windscreen

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure cover (1) is correctly seated on side panel (2) and seal (3).

Fig 3: Identifying Cover, Side Panel And Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Lift cover (1) upwards slightly.

Pull tube (2) out of cover (1).

Remove line (3) together with rubber seal from cover (1).

Fig 4: Pulling Tube Out Of Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip line (2) from holders (1).

Removing cowl panel cover

Fig 5: Identifying Holders

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace defective grommets (1).

Check holder (2) for correct seating.

Fig 6: Identifying Grommets And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clips (1) must not be missing or damaged.

Apply some butyl (sourcing reference: BMW Parts Service) in corners of cover (2) in area (3):

Remove excess butyl from windscreen.

Fig 7: Identifying Clips

Courtesy of BMW OF NORTH AMERICA, INC.