72 12 010 Removing And Installing/Replacing Airbag Module On Left Or Right Front Door

WARNING:

Read and comply with SAFETY REGULATIONS for handling airbag modules and pyrotechnical belt tensioners.

Incorrect handling can activate airbag and cause injury.

Necessary preliminary tasks:

Disconnect battery negative lead
Follow instructions for disconnecting and connecting battery!
REMOVE FRONT DOOR TRIM

Release nuts (1) and remove holder (2).

Installation:

Tightening torque: 72 12 01AZ . See AIRBAG MODULES for specs.

Coat nut and thread with paint (any color and type can be chosen).

Fig 1: Identifying Holder And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Fold back tabs (1) of plastic housing and remove airbag module (2) from airbag mounting.

Fig 2: Removing Airbag Module From Airbag Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

There must be no foreign bodies (e.g. screws, nuts, etc.) in the airbag mounting (1).

Fig 3: Identifying Fold Back Tabs

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slots (2) of holder (1) must be above threaded pins (3).

Point angled part of holder (1) to door trim panel.

Fig 4: Identifying Slots Of Holder And Threaded Pins

Courtesy of BMW OF NORTH AMERICA, INC.