12 61 280 Removing And Installing/Replacing Oil Pressure Switch (N62, N62TU)
Necessary preliminary tasks:
- Switch off ignition
- E65/E66 only: Remove intake filter housing
- E53 only: Remove intake hood with air intake hose
WARNING:
Scalding hazard!
Only perform this task on an engine that has cooled down.
Installation location:
Cylinder bank 1 to 4 on cylinder head, front right.
Engine oil may emerge when oil pressure switch is replaced; have a cleaning cloth ready.
Release plug connector (1) and pull off.
Unscrew oil pressure switch (2).
Tightening torque: 12 61 1AZ . See ENGINE - TIGHTENING TORQUES .
Installation:
Check engine oil level, top up engine oil if necessary.