32 33 001 Removing And Installing/Replacing Steering Wheel (BMW ALPINA B7)

IMPORTANT: Do not twist volute spring cassette.
When installing, make sure that the locking pin on the rear side of the steering wheel engages in the driver recess.

Necessary preliminary tasks:

Remove airbag unit . See 32 34 020 REMOVING AND INSTALLING/REPLACING AIRBAG UNIT (BASIC STEERING WHEEL) .
Move steering wheel to straight-ahead position

Replacement only:

Release screws (1).

IMPORTANT: Risk of breakage!
Carefully remove multifunction steering wheel switches with decorative strips and retaining plate (2) from steering wheel.

Disconnect plug connections on rear side.

Installation:

Make sure connecting cables are correctly routed.

Fig 1: Identifying Retaining Plate And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Make sure that decorative strips and both multifunction steering wheel switches are correctly positioned on steering wheel (guide pins must not be damaged).

Tightening torque 32 33 2AZ . See STEERING AND WHEEL ALIGNMENT - TIGHTENING TORQUES .

Unfasten plug connection.

Remove connecting lead(s) from steering wheel.

Release screw (1) and remove steering wheel.

Secure volute spring cassette with adhesive tape against twisting.

Installation:

Make sure connecting lead(s) is/are correctly laid.

Tightening torque 32 33 1AZ . See STEERING AND WHEEL ALIGNMENT - TIGHTENING TORQUES .

Fig 2: Releasing Steering Wheel Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Locking pin (1) must engage in recess of driver (2).

Align steering wheel using grooved toothing to steering column and attach.

Fig 3: Engaging Locking Pin In Recess Of Driver

Courtesy of BMW OF NORTH AMERICA, INC.