32 00 620 Adjusting Rear Axle

NOTE: A camber change always means a toe change as well. The camber must therefore be adjusted first.

Adjusting camber:

Replace nut (2) and tighten to 5 Nm.

Turn eccentric bolt (1) to adjust camber to setpoint value.

Tighten nut (2).

Tightening torque 33 32 20AZ . See REAR AXLE - TIGHTENING TORQUES .

Fig 1: Turning Eccentric Bolt (Adjusting Camber)

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting toe:

Replace nut (2) and tighten to 5 Nm.

Turn eccentric bolt (1) to adjust toe to specified value.

Tighten nut (2).

Tightening torque 33 32 5AZ . See REAR AXLE - TIGHTENING TORQUES .

Fig 2: Turning Eccentric Bolt (Adjusting Toe)

Courtesy of BMW OF NORTH AMERICA, INC.