33 55 021 Replacing Both Rubber Mounts For Stabilizer Mounting
IMPORTANT:
Observe safety when raising the vehicle.
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off pipe connections with plugs.
Seal off pipe connections with plugs.
After installation:
- Version with ride-height control: Activate and fill air suspension system . See 37 00 100 DRAINING/FILLING AIR SPRING SYSTEM .
- Version with Dynamic Drive:
- Fill and bleed hydraulic system . See 32 13 006 BLEEDING POWER STEERING (VERSION WITH DYNAMIC DRIVE) or 32 13 006 BLEEDING POWER STEERING UNIT .
- Check pipe connections for leaks
- Carry out initial Dynamic Drive operation . See 37 10 001 INITIAL OPERATION WITH TEST RUN OF DYNAMIC DRIVE .
- Adjusting parking brake . See 34 41 006 ADJUSTING PARKING BRAKE .
Necessary preliminary tasks:
- Remove complete rear axle carrier . See 33 31 000 REMOVING AND INSTALLING COMPLETE REAR AXLE CARRIER .
Release screws (1) on both sides.
Tightening torque 33 55 3AZ . See REAR AXLE - TIGHTENING TORQUES .
Remove retaining bracket (2) on both sides.
Remove rubber mount (3) on both sides.
Installation:
Keep retaining bracket (2), rubber mount (3) and stabilizer clean and free from oil and grease.
Version with Dynamic Drive: Keep contact face for rubber mount on anti-friction bearing clean and free from oil and grease.