37 10 005 Removing and Installing/Replacing Vent Hose (From 06/2003) For Active Stabilizer (Front)

Necessary preliminary tasks: 

• Remove front assembly underside protection  See 51 47 490 REMOVING AND INSTALLING/REPLACING FRONT UNDERBODY PROTECTION

Release banjo bolts (2) and remove vent hose (3).

Tightening torque 37 11 2AZ  . See 37 11 CONTROL AND SUSPENSION ELEMENTS, FRONT

Disconnect vent hose (3) from Y-distributor.

Unscrew vent valves (1) from oscillating motor.

Installation: 

If necessary, fit new vent valves (see note at end of document).

Tightening torque 37 11 1AZ  . See 37 11 CONTROL AND SUSPENSION ELEMENTS, FRONT

Unclip cover (1) and pull filter out of front axle carrier.

Expose vent hose (2) up to Y-distributor and remove.

Replacing vent valve: 

Screw vent valve (1) fully into oscillating motor and remove plug.

Slide vent hose (2) into vent valve (1) up to second marking (M).