65 77 740 Removing and Installing (Replacing) Left Front Door Sensor
WARNING:
Note airbag safety instructions! See 72 00 ... SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS
Incorrect handling can activate airbag and cause injury.
NOTE:
Follow instructions for handling optical fibers
. See 61 00 ... NOTES ON HANDLING OPTICAL FIBERS
Necessary preliminary tasks:
- Disconnect battery negative lead See 61 20 900 DISCONNECTING AND CONNECTING BATTERY NEGATIVE LEAD
- Remove control unit in left front door See 61 35 220 REMOVING AND INSTALLING (REPLACING) CONTROL UNIT FOR LEFT OR RIGHT FRONT DOOR
Disconnect plug connection (1).
Release screws (2) and remove front door sensor (3).
Installation:
Make sure sensor is mounted without play.
For tightening torque 65 77 7AZ , see 65 77 AIRBAG TRIGGERING CONTROL
Installation:
Check seal (1), replace if necessary.
Make sure seal (1) for front door sensor is correctly seated.
Replacement only:
Carry out coding/programming .