41 00... Stamping Vehicle Identification Number

Special tools required:

41 0 000
41 1 070
41 1 071
41 1 072

NOTE: If the stamped vehicle identification number is removed during repair work, it must be stamped in again.
Read and comply with General Information.

Necessary preliminary tasks:

Remove front right spring strut . See 31 31 000 REMOVING AND INSTALLING COMPLETE LEFT OR RIGHT SPRING STRUT SHOCK ABSORBER .

Special tool kit 41 1 070 for stamping vehicle identification number consists of:

Guide plate 41 1 071 (1)

Counter-support plate 41 1 072 (2).

Fig 1: Identifying Guide Plate And Counter-Support Plate

Courtesy of BMW OF NORTH AMERICA, INC.

Fit special tool 41 1 072 (2) at bottom to spring strut support plate.

Position special tool 41 1 071 (1) at top on spring strut support plate and secure.

Fig 2: Positioning Special Tool At Top On Spring Strut Support Plate

Courtesy of BMW OF NORTH AMERICA, INC.

Insert punch numbers 41 0 000 (1) individually into guide plate (2) and stamp vehicle identification number.

Fig 3: Inserting Punch Numbers (41 0 000) Into Guide Plate

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: In the event of component or body replacement by the workshops/garages, clearly delimit the vehicle identification number at front and rear by stamping a "+" in place of the BMW emblem.
Note national regulations.