41 00... FRAME ALIGNMENT CONTROL BODY DIMENSIONS (750i)
Dimensions in mm.
Measurement tolerances:
- ≤ 1000 mm ± 1 mm
- ≥ 1000 mm ± 2 mm
The control points shown serve to check the body and the straightening attachment.
The specified dimensions/measurements always refer to the centerpoint of the bore/screw.
Under Body View 1
Fig 1: Under Body Frame Alignment Control Dimensions And Measurement Points (750i) (Under Body View 1)
Under Body View 2
Fig 2: Under Body Frame Alignment Control Dimensions And Measurement Points (750i) (Under Body View 2)
Top View, Front End
Fig 3: Engine Compartment Frame Alignment Control Dimensions And Measurement Points (750i) (Top View, Front End)
View, B-Pillar
Measurement a=1657 mm between screw-on points of lock strikers.