63 21 183 Removing And Installing/Replacing Left Or Right Rear Light (From 03/2005) (On Rear Lid)

IMPORTANT:

Read and comply with notes on protection against electrostatic damage (ESD PROTECTION)

Necessary preliminary tasks:

Detach trim (1) in area (A) of rear light (2) downwards.

Area (B) of trim (1) remains on vehicle.

Installation:

Ensure trim (1) is correctly seated.

Fig 1: Identifying Screws And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unscrew nuts (2).

NOTE:

Secure rear light against falling out.

Unclip rear light (1) and remove.

Fig 2: Identifying Top Rail, Bottom Rail And Gas Cartridge

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clip (2).

Make sure there is a uniform gap (outer) all round for rear lid.

Make sure sealing frame for rear light is correctly seated; replace SEALING FRAME if necessary.

Fig 3: Identifying Gas Cartridge And Guide Lug

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If necessary, remove BULB .