61 67 083 Removing and installing / replacing left or right high-pressure nozzle of headlight washer system

Special tools required: 

• 13 3 010

Necessary preliminary tasks: 

• Remove Front Bumper Trim

To prevent excessive escape of washer fluid, seal off end of high-pressure line with special tool 13 3 010.

Fig 1: Identifying Special Tool (13 3 010) Sealing High-Pressure Line

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock catch (1) in direction of arrow.

Remove high-pressure nozzle (2) towards rear from headlight arm (3).

Unlock high-pressure line and detach from high-pressure nozzle.

Installation: 

Keep plug connection for high-pressure nozzle (2) and high-pressure line clean and free from grease.

Fig 2: Identifying High-Pressure Nozzle, Catch And Headlight Arm

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Ensure that guide (2) is correctly seated.

Make sure retaining lugs (1) engage correctly.

Carry out a function test before fitting bumper trim.

If necessary, adjustment can be carried out carefully using pointed pliers (tape of front area with adhesive tape where necessary).

Fig 3: Identifying Guide And Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.