61 35 107 Removing and installing/replacing Junction Box electronics
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with Notes On Protection Against Electrostatic Damage (ESD Protection) .
Necessary preliminary tasks:
- Disconnect Battery Negative Lead
- Remove Footwell Side Trim Panel on A-pillar, right
- Remove Trim For Instrument Panel , bottom right
NOTE:
Right glovebox shown removed for purposes of clarity.
Unlock plug connections (1) and disconnect.
Release screws (2) and remove junction box electronics (3) from bracket.
Unlock plug connections (1) and disconnect.
Installation:
Make sure junction box electronics is correctly seated in plug connection (2) of bracket.
Replacement:
- Carry out Programming/Coding.
- Delete transport mode