61 31 270 Removing and installing/replacing switch for reversing light (DME)

WARNING: This page is about a different variant/trim than selected.

NOTE: The installation location of the reversing light switch can vary, depending on the transmission model.

Necessary preliminary tasks:

Version A:

Disconnect plug connection (1).

Release switch for reversing light (2).

For tightening torque refer to 61 31 2AZ in 61 31 SWITCH .

Fig 1: Identifying Version A Plug Connection And Reversing Light

Courtesy of BMW OF NORTH AMERICA, INC.

Version B:

Disconnect plug connection (1).

Release switch for reversing light (2).

For tightening torque refer to 61 31 2AZ in 61 31 SWITCH .

Fig 2: Identifying Version B Plug Connection And Reversing Light

Courtesy of BMW OF NORTH AMERICA, INC.