63 12 010 Removing and installing/replacing left headlight (xenon headlight)

WARNING: This page is about a different variant/trim than selected.

WARNING: Version with xenon headlights: Danger to life due to high voltage! Therefore, before removing, disconnect all components from the power supply (lighting system and ignition off).

Work on the entire xenon lighting system (control unit, ignition unit with bulb) may only be carried out by specialist personnel.

Follow Instructions For Handling Light Bulbs (Exterior Lights) .

IMPORTANT: Read and comply with Notes On Protection Against Electrostatic Damage (ESD Protection) .

Necessary preliminary tasks:

Remove Front Bumper Trim

Unlock catches (1) in direction of arrow and remove high-pressure nozzle (2) towards rear out of headlight arm (3).

Fig 1: Identifying Headlight Arm, Nozzle And Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) on headlight arm (2) (from wheel arch side).

For tightening torque refer to 63 12 1AZ in 63 12 HEADLIGHTS .

Fig 2: Identifying Headlight Arm And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1). For tightening torque refer to 63 12 1AZ in 63 12 HEADLIGHTS .

Installation:

If necessary, unclip electric lead (2) from headlight arm. Pull out headlight (3) slightly and unlock and disconnect associated plug connection.

Remove headlight (3) towards front.

Fig 3: Identifying Screws, Wiring Harness And Headlight

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1) (for tightening torque refer to 63 12 2AZ in 63 12 HEADLIGHTS ) and remove headlight arm (2) from headlight.
Remove Ignition Unit With Bulb For Xenon Headlight
Remove Control Unit For Xenon Headlights
If necessary, Remove Bulbs .

Fig 4: Identifying Headlight Arm And Screws

Courtesy of BMW OF NORTH AMERICA, INC.