00 00 610 Engine oil service incl. supplementary service (N52)
Special tools required:
- 11 9 240
Overfilling the engine with engine oil will result in engine damage.
Checking and drip-off times must be observed.
Recycling:
Catch and dispose of used oil in a suitable container.
Observe country-specific waste-disposal regulations.
Release oil filter cap with special tool 11 9 240.
Remove and insert oil filter element (1) in direction of arrow.
Replace O-rings (2).
Installation:
Lubricate all O-rings (2) with engine oil.
For tightening torque refer to 11 42 1AZ in 11 42 020 REMOVING AND INSTALLING/REPLACING FULLFLOW OIL FILTER (N52) .
Remove engine oil drain plug (1).
Installation:
Replace sealing ring.
For tightening torque refer to 11 13 1AZ in 11 13 000 REMOVING AND INSTALLING, SEALING OR REPLACING OIL SUMP (N52)
Assemble engine.
Checking engine oil level:
- Park vehicle on a horizontal surface.
- Allow engine at normal operating temperature to run for 3 minutes with increased revs (approx. 1100 rpm).
- Read off engine oil level in instrument cluster or on Control Display.