LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2007 >> 335i 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Maintenance And General Information - Repair - E90/E91) >> 00 ... ... Raising vehicle with trolley jack

00 ... ... Raising vehicle with trolley jack

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Observe the following trolley-jack-related instructions: 
  1. Use only BMW-distributed/approved trolley jacks which have rubber plate contact points.
  2. Trolley jacks must be regularly serviced and always checked for functional reliability before they are used!
  3. Check the rubber plate on the trolley jack prior to each replacing if necessary.
    Fig 1: Identifying BMW Trolley Jacks
    G04725307Courtesy of BMW OF NORTH AMERICA, INC.
WARNING: The vehicle may be raised with a trolley jack only  at the following jacking points!
  1. Car jacking point on reinforcement strut (rear-wheel drive)
  2. Side car jacking points
  3. Rear differential

    Risk of damage: It is not permitted to raise the vehicle at the rear differential cover!

    Fig 2: Identifying Reinforcement Strut, Rear Differential And Side Car Jacking Points
    G04725308Courtesy of BMW OF NORTH AMERICA, INC.
  1. Car jacking point on front axle carrier (all-wheel drive)
    Fig 3: Identifying Car Jacking Point On Front Axle Carrier
    G04725309Courtesy of BMW OF NORTH AMERICA, INC.