64 12 ... Initializing Telestart hand transmitter (from build date 03/2007)
WARNING: This page is about a different variant/trim than selected.
NOTE:
The Telestart hand transmitter must be initialized when:
- Hand transmitter is replaced
- Car Access System control unit is replaced
The independent heating is switched on under an outside temperature of approx. 15°C with the hand transmitter and at a preselected switch-on time.
Direct activation is possible at any outside temperature via the "Climate" menu item in the i-Drive, but not in driving mode.
To initialize a new hand transmitter, perform the following operations from inside the vehicle:
- Close all doors on vehicle (vehicle must be unlocked!)
- Within 5 seconds: Turn ignition lock from terminal "0" to terminal "R" and then back to terminal "0" (by inserting and removing key, insertion duration: 1 to 5 secs.)
- Within 5 seconds: Simultaneously press both buttons (1, 2) on hand transmitter until LED (3) lights up orange.
- Release both buttons. Briefly press ON button (1) three times within 10 seconds; LED (3) flashes orange as confirmation.
NOTE:
The vehicle's central locking closes and opens automatically on successful initialization.
The initialization process must be repeated if there is no checkback signal from the central locking system.