64 11 839 Replacing servodrive for footwell flap (automatic A/C)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Servomotors must be re-addressed in the event of replacement!

Addressing can only be carried out with the BMW diagnosis system.

Service functions:

Body
Heating and A/C function
Flap motors
Re-address flap motors

Necessary preliminary tasks:

Remove Right Glovebox With Housing

Detach right footwell heating duct (1) in area (2) in direction of arrow.

Detach right footwell heating duct (1) with adapter (3) from heater/air conditioner and remove in direction of arrow from right rear compartment heating duct (4).

Fig 1: Identifying Right Footwell Heating Duct, Adapter And Right Rear Compartment Heating Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Release screws (2) and (3).

Detach bracket (4) complete with servodrives from heater/air conditioner (5).

Installation:

Make sure bracket (4) is correctly seated on heater/air conditioner (5).

Fig 2: Identifying Bracket, Heater/Air Conditioner Servodrives, Plug Connection And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove servodrive for footwell flap (2) from bracket (3).

Installation:

Place servodrive for footwell flap (2) over guide pin (4).

Fig 3: Identifying Screws, Guide Pin, Bracket And Footwell Flap Servodrive

Courtesy of BMW OF NORTH AMERICA, INC.