64 11 378 Removing and installing/replacing heater/air conditioner operator unit (version with CCC/ASK)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

C ar C ommunication C omputer (CCC)

A udio S ystem K ontroller / Controller (ASK)

Necessary preliminary tasks:

NOTE: Unclip the heater/air conditioner operator unit (2) by simultaneously

Fit special tool 00 9 340 on either side as illustrated.

Unclip heater/air conditioner operator unit (2) complete with trim (1) at fastening points (4) and pull back.

Unlock associated plug connections and disconnect.

Remove heater/air conditioner operator unit (2) complete with trim (1).

Fig 1: Identifying Control Button, Fastening Points, Heater A/C Unit And Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carefully unclip operator unit trim (1) at inner retaining points (2) only.

IMPORTANT: Risk of damage to operator unit!

Fig 2: Identifying Retaining Bolts And Operator Unit Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully unclip operator unit trim (1) at outer retaining points (2) only.

Remove trim (1) from operator unit (3).

IMPORTANT: Risk of damage to operator unit (3)!

Fig 3: Identifying Trim, Retaining Points And Operator Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out programming/coding.