64 11 377 Removing and installing/replacing heater/air conditioner operator unit (version without CCC/ASK)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

NOTE: C ar C ommunication C omputer (CCC)
A udio S ystem K ontroller / Controller (ASK)

Lever out heater/air conditioner operator unit (1) with special tool 00 9 340 and pull.

Disconnect associated plug connections.

Remove heater/air conditioner operator unit (1) complete with centre console switch cluster (2) and trim (3).

Fig 1: Identifying Heater/Air Conditioner Operator Unit, Centre Console Switch Cluster And Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carefully unclip operator unit trim (1) at inner retaining points (2) only.

IMPORTANT: Risk of damage to operator unit (3)!

Fig 2: Identifying Operator Unit, Trim And Inner Retaining Points

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully unclip operator unit trim (1) at outer retaining points (2) only.

Remove trim (1) from operator unit (3).

Fig 3: Identifying Operator Unit, Trim And Outer Retaining Points

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out programming/coding.