65 77 541 Removing and installing/replacing front left or right acceleration sensor

WARNING: This page is about a different variant/trim than selected.

NOTE: Acceleration sensor only fitted in US version!

Unlock plastic fasteners (1) by turning counterclockwise through 180°.

Feed flap (2) in direction of arrow out of front wheel arch cover (3) and remove.

Fig 1: Identifying Plastic Fasteners, Flap And Front Wheel Arch Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove acceleration sensor (2).

Disconnect plug connection (3).

Installation:

Replace screws (1).

For tightening torque refer to 65 77 9AZ in 65 77 AIRBAG TRIGGERING CONTROL .

Fig 2: Identifying Mounting Screws, Plug Connection And Acceleration Sensor

Courtesy of BMW OF NORTH AMERICA, INC.