65 75 055 Removing and installing/replacing emergency power siren with tilt sensor

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release screws (1) and lower complete mounting plate (2).

Unlock and disconnect associated plug connection, remove complete mounting plate (2).

Fig 1: Identifying Mounting Plate And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) and remove emergency power siren with tilt sensor (2) from mounting plate (3).

Fig 2: Identifying Mounting Plate, Tilt Sensor And Nut

Courtesy of BMW OF NORTH AMERICA, INC.