66 31 001 Adjusting ACC sensor

WARNING: This page is about a different variant/trim than selected.

Special tools required:

36 1 100
66 3 150

Unclip trim (1) at points (2) and remove towards front from bumper trim (3).

Fig 1: Identifying Front Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure trim (1) is correctly seated.

Locking hooks (2) must not be damaged.

Fig 2: Identifying Locking Hooks

Courtesy of BMW OF NORTH AMERICA, INC.

Carry out adjustment of ACC sensor (1) with special tool 66 3 150 by means of adjusting screws (2).

Fig 3: Identifying Special Tool (66 3 150)

Courtesy of BMW OF NORTH AMERICA, INC.

Special tool required:

Active Cruise Control ACC adjusting device, complete.

Order number: 81 10 0 021 292 Consisting of:

Mirror, complete
Wheel laser
Slotted diaphragm
Control bracket (for initial installation of rail)
Rail
Setup and operating instructions (not shown)

Fig 4: Identifying Wheel Laser, Slotted Diaphragm And Control Bracket
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: A holder which is not included in the scope of delivery is required to support the wheel laser. Use either the quick-action clamp from the existing KDS or ACC wheel holder (36 1 100).

NOTE:

Follow instructions for ACC adjusting device.

NOTE: To adjust the ACC sensor, connect the BMW diagnosis system and fit the ACC adjusting device.
Select ACC system in diagnosis. Start test module "ACC adjustment" (service functions) and proceed in accordance with instructions.
Handle ACC adjusting device in accordance with mounting and operating instructions provided with device.