25 11 111 Replacing shift rod joint

Necessary preliminary tasks: 

• Release propeller shaft at transmission and centre mount. Tie propeller shaft to one side.

  Tasks are described in Removing Propeller Shaft .

• Remove transfer case (AWD)

Lift off retainer (1).

Disconnect shift rod (2).

Fig 1: Identifying Retainer And Shift Rod

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Grease shift rod.

Grease, refer to BMW Service Operating Fluids .

Make sure shims (3) are in correct position.

Lever spring washer (1) out of groove and push a little towards rear.

Press dowel pin (2) upwards/downwards out of shift rod joint and remove shift rod joint.

Installation: 

Grease ball of selector shaft.

Grease, refer to BMW Service Operating Fluids .

Replace spring washer (1).

Fig 2: Identifying Spring Washer And Shift Rod Joint Dowel Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Check rubber ring (1) in shift rod joint (2) and replace if necessary.

Fig 3: Check Rubber Ring In Shift Rod Joint

Courtesy of BMW OF NORTH AMERICA, INC.