26 11 051 Replacing flexible disk for front propeller shaft
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove COMPLETE EXHAUST SYSTEM .
- Remove heat shields.
- Remove Propeller Shaft from transmission and centre mount.
NOTE:
To protect universal joints, tie back propeller shaft in area of centre mount.
Release screws and remove flexible disk (1) from propeller shaft.
IMPORTANT:
Replace shiny ZNS bolts and self-locking nuts.
Tightening torque and angle of rotation: 26 11 1AZ. Refer to 26 11 PROPELLER SHAFT COMPLETE .
Installation:
- Arrows (3) on circumference of flexible disk must point flange arms (2).
- Grip mounting bolts of flexible disk at propeller shaft flange at nuts and tighten down at bolt heads.
Installation:
Check centering mount.
Replace damaged Centering Mount .