67 62 020 Removing and installing/replacing flat motor for rear left or right power window unit

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release screws (1). For tightening torque, see 51 35 1AZ in 67 62 DRIVES, POWER WINDOWS .

Detach flat motor for power window unit (2) in direction of arrow from power window unit (3).

Installation:

Fit flat motor for power window unit (2) exactly on teeth of power window unit.

Fig 1: Detaching Flat Motor For Power Window Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

A normalization must be carried out in order to activate anti-trapping protection.

Operating sequence for normalization:

Operate corresponding power window switch in "Close" setting.
Once the upper end position has been reached, hold power window switch down for approx. 1 second more.

If necessary, repeat procedure again.

Normalization is thus completed.

NOTE: Carry out function check (one-touch function, anti-trapping protection and, if necessary, comfort function.