32 41 100 Removing and installing/replacing belt pulley on vane pump for power steering
WARNING: This page is about a different variant/trim than selected.
NOTE:
Carry out preliminary work as described in the document "Replacing drive belt
".
Slacken bolts (1)
Relieve tension on Drive Belt and remove from belt pulley (2).
Unscrew bolts (1) and remove belt pulley (2).
Installation:
Lettering on belt pulley (2) must point forwards.
For tightening torque refer to 32 41 3AZ in 32 41 PUMP AND OIL SUPPLY .