32 34 030 Removing and installing / replacing airbag unit (sport steering wheel)
WARNING: This page is about a different variant/trim than selected.
WARNING:
Observe the following instructions to avoid any risk of injury by the airbag unit.
- Comply with Safety Regulations For Handling Components Gas Generators .
- Do not exert any force on the airbag unit.
- Use only specified tools for releasing the airbag unit.
NOTE:
Incorrect handling may result in triggering of the airbag unit and thereby cause serious injury.
IMPORTANT:
Steering Wheel must be replaced if airbag unit has been triggered!
Necessary preliminary tasks:
- Disconnect Battery Negative Lead
Insert Torx screwdriver (T25) at an angle into concealed opening on reverse side of steering wheel until a spring resistance is felt (approx. 1.5 cm).
Increase pressure on spring leg (concealed) using Torx screwdriver (T25) until airbag unit is unlocked.
Repeat procedure on other side.
Installation:
Make sure electrical leads are correctly positioned.
Snap airbag unit with uniform pressing force plane-parallel in direction of steering column shaft into steering wheel.
WARNING:
Danger of injury!
Airbag unit may only be set down with the airbag itself facing upwards .
Tilt airbag unit forwards.
Disconnect plug connections and remove airbag unit.
Installation:
Connect plugs to connections of same color on airbag unit.