31 00... Front axle + steering: wheel/chassis alignment check must be carried out after the following work

Fig 1: Identifying Front Axle Carrier, Steering Gear, Control Arm, Swivel Bearing And Tie Rod End

Courtesy of BMW OF NORTH AMERICA, INC.

A Wheel/Chassis Alignment Check must be carried out after the following work:

• Release of following screw/bolt connections: 
  • Steering gear to front axle carrier
  • Control arm to front axle carrier
  • Support bearing to body (if centering pin is missing)
  • Tie rod end to tie rod
• Replacement of following parts: 
  1. Front axle carrier
  2. Steering gear
  3. Gaiter (if the tie rod end has to be screwed off)
  4. Control arm
  5. Support bearing (if centering pin is missing)
  6. Swivel bearing
  7. Tie rod end
  8. Tie rod