Two-part underbody protection

WARNING: This page is about a different variant/trim than selected.

Release screws (1).

Detach underbody protection (2) from bracket (3) and remove.

Installation:

Ensure correct seating.

Centre underbody protection (2) and tighten down screws (1).

Fig 1: Identifying Two-Part Underbody Protection, Mounting Bracket And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Single-part underbody protection (E90/E91/E92 AWD):

Release screws (1).

Remove underbody protection (2) downwards.

Installation:

Ensure correct seating.

Centre underbody protection (2) and tighten down screws (1).

Fig 2: Identifying Single-Part Underbody Protection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.