51 47 490 Removing and installing / replacing front assembly underside protection

WARNING: This page is about a different variant/trim than selected.

NOTE: Illustration created using E87 120i as an example. There may be differences in detail in the case of other models.

Release screws (1).

Pull underbody protection (2) forward under bumper trim (3).

Installation:

Centre underbody protection (2) and tighten down screws (1).

Fig 1: Identifying Underbody Protection, Bumper Trim And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: