34 52 535 Replacing a rear pulse generator

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Unscrew nut (1).

Pull wheel arch trim (2) gently to one side.

Disengage cable from holders (3).

Fig 1: Identifying Rear Wheel Arch Trim, And Mounting Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Installation:

Ensure proper locking of the plug connector and proper seating of the cable in the brackets.

Fig 2: Identifying Rear Pulse Generator Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage cable from holders (1).

Unfasten socket head cap screw (2).

Withdraw wheel speed sensor (3) from bore hole.

Installation:

For tightening torque refer to 34 51 4AZ in 34 51 SLIP CONTROL SYSTEM (DSC) .

Clean bore hole for pulse generator and grease with Staburags NBU 12/K lubricating grease (refer to BMW Service Operating Fluids ).

Fig 3: Identifying Wheel Speed Sensor, Cable Holder And Cap Screw

Courtesy of BMW OF NORTH AMERICA, INC.