34 41 220 Removing and installing/replacing all handbrake shoes

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

After completing work:

Release handbrake lever.

Lock adjuster unit (ASZE).

Using special tool 32 1 030, press stop (1) of adjusting spring back to such an extent that retaining hook (2) engages in stop (1).

Fig 1: Identifying Special Tool (32 1 030), Retaining Hook And Stop

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect return spring (1) with brake spring pliers.

Installation:

Check and if necessary replace return spring (1).

Pay attention to installation position of adjustment screw (2).

Apply a thin coat of Grease to bush and screw threads.

Fig 2: Identifying Handbrake Return Spring And Adjustment Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect return spring (1) with brake spring pliers.

Installation:

Check and if necessary replace return spring (1).

Fig 3: Identifying Handbrake Return Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Turn clamping pins (1) with special tool 34 4 000 through 90° and disconnect.

Remove brake shoes (2).

Fig 4: Identifying Special Tool (34 4 000), Clamping Pins And Brake Shoes

Courtesy of BMW OF NORTH AMERICA, INC.