34 32 861 Replacing all brake pipes
WARNING: This page is about a different variant/trim than selected.
Special tools required:
- 34 5 100
NOTE:
The brake lines are only supplied in the straight version and correct length with connecting nipple.
Read and comply with General Information.
After completing work, bleed Braking System .
New brake lines are bent into shape with bending tool 34 5 100.
Removed brake pipes can be used as templates for bending.
IMPORTANT:
- Protective coating of brake line must not be damaged during bending.
- Do not kink or bend back brake lines.
- Watch distances to rigid and movable vehicle parts. Brake lines may not make contact or rub.
- Tighten down brake line couplings with torque wrench.
Installation:
For tightening torque refer to 34 32 1AZ in34 32 BRAKE LINES .