36 11 533 Removing and installing / replacing RDC wheel electronics: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools required:
- 00 2 190
NOTE:
If a tyre sealant has been used, replace the wheel electronics.
When a tyre has been removed, do not clean the rim with installed wheel electronics with high-pressure cleaning equipment.
Do not treat wheel electronics with solvents, cleaning agents etc. If dirty, wipe with a clean cloth only.
Do not clean wheel electronics with compressed air.
IMPORTANT:
If the wheel electronics have been removed, the complete valve must be replaced.
Necessary preliminary tasks:
- Remove Tyre