41 34 041 Tail Panel Complete Replacement

WARNING: This page is about a different variant/trim than selected.

Read contents of Body, General.

Use only approved Spot-Welding Apparatus for repairs!

Following new body parts are required:

(1) Rear trim

Fig 1: Identifying Rear Trim
Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Open brazed joints in areas (2).

Fig 2: Identifying Weld Joints And Brazed Joints Area (1 Of 3)

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Fig 3: Identifying Weld Joints Area (2 Of 3)

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation of new part:

Open weld joints in areas (1).

Remove reinforcements (2).

NOTE: This work step is omitted if the rear side panels are replaced at the same time.

Fig 4: Identifying New Part Weld Joints Area And Reinforcements (3 Of 3)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide in rear trim (1) from bottom upwards.

Fig 5: Identifying Rear Trim Installation

Courtesy of BMW OF NORTH AMERICA, INC.