51 16 206 Removing and installing / replacing centre armrest

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

IMPORTANT: Grip behind trim (1) from below and release catch (2) (risk of damage).

Pull trim (2) towards rear and release from catches (3).

Fig 1: Identifying Trim And Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1 and 3) must not be damaged.

Guides (2) must not be damaged.

If necessary, release Rear Compartment Fresh-Air Grille in order to install trim correctly.

Fig 2: Identifying Catches And Guides

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Open centre armrest otherwise spring (1) will be under too much tension.

Disengage spring (1) with screwdriver (2).

Installation:

Make sure spring (1) is correctly seated.

Fig 3: Identifying Armrest Spring And Screwdriver

Courtesy of BMW OF NORTH AMERICA, INC.

Drive out hinge shafts (1).

NOTE: Hinge shafts (1) are secured on the outside with toothing (3).

Remove spring (2), open centre armrest and feed out of storage compartment.

Fig 4: Identifying Hinge Shafts, Toothing And Spring

Courtesy of BMW OF NORTH AMERICA, INC.