51 13 025 Removing and installing/replacing left or right trim on engine hood/bonnet

WARNING: This page is about a different variant/trim than selected.

Release screws (1) and remove trim (2) in upwards direction.

For tightening torque refer to 51 13 7AZ in 51 13 TRIM PARTS, COVERS, HANDLE TRIM .

Fig 1: Identifying Engine Hood/Bonnet Trim And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Guides (1) on trim (2) must not be damaged.

Fig 2: Identifying Guides And Engine Hood/Bonnet Trim

Courtesy of BMW OF NORTH AMERICA, INC.