51 12 821 Replacing both holders for rear bumper

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

NOTE: The operation is described on the left side; proceed in the same way for the right side.

E93 only:

Release antenna holders (1 and 2) from holder (3).

Installation:

If necessary, replace faulty antenna holders (1 and 2).

Fig 1: Identifying Antenna Holders And Rear Bumper Holder

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, disconnect plug connection at trigger transmitter.

Release screws (1 and 2).

Release nut (3) and remove holder (4).

Fig 2: Identifying Rear Bumper Holder, Nut And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) must not be damaged or missing.

E90/E91 only:

Catches (2) must not be damaged or missing.

Replacement:

If necessary, remove RDC trigger transmitter.

Fig 3: Identifying Rear Bumper Holder Catches

Courtesy of BMW OF NORTH AMERICA, INC.