51 12 ... Replacing trim on rear bumper (M Technic aerodynamic kit)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Carefully heat trim (1) with hot air blower and detach with special tool 00 9 317 from bumper (2).

Fig 1: Identifying Special Tool (00 9 317), Trim And Rear Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Minimum object temperature of trim and bumper ≥, 18°C.

If this temperature is not achieved, the components must be preheated.

For cleaning, use a fluff-free disposable cloth or a clean cleaning cloth.

Clean adhesive area of bumper with spirit.

Air drying time at least 1 minute.

Installation:

Trim (1) is positioned over guides (2) on bumper.

Remove liner from trim (1).

Press down trim (1) firmly with back of your hands over entire surface, especially the ends.

Fig 2: Identifying Trim And Guides

Courtesy of BMW OF NORTH AMERICA, INC.