54 12 211 Removing and installing complete glass slide/tilt sunroof
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove Roofliner
IMPORTANT:
A second person is required to help in removing the glass slide/tilt sunroof.
- Unfasten plug connection (1) and disconnect.
- Detach water drain hoses.
- Helper must hold glass slide/tilt sunroof to prevent it falling out.
- Release screws in marked area and carefully lower glass slide/tilt sunroof.
For tightening torque refer to 54 12 6AZ in 54 12 MECHANICAL SUN ROOF COMPONENTS .
IMPORTANT:
Do not damage any surrounding parts when removing the glass slide/tilt sunroof.
- Remove glass slide/tilt sunroof completely (through rear lid at rear).
Installation:
If necessary, remove fabric adhesive tape.
To stop grating noises, secure all screws (1) prior to installation with plastic washers (2).
If the standard screws can no longer grip, use "repair screws" (have larger threads).
IMPORTANT:
Do not crush any cables when fitting the glass slide/tilt sunroof.
Initialize glass slide/tilt sunroof.