51 47 030 Removing and installing/replacing (inside) rear left or right entrance cover strip
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.
Necessary preliminary tasks:
With basic seat:
- Partially remove BACKREST .
With SA through-loading system:
- Remove ARMREST SIDE SECTION
- Partially remove REAR SEAT
Detach plastic rivet (2) from entrance cover strip (1).
Carefully lever off entrance cover strip (1) with special tool 00 9 325 starting in the center, then in the front and rear and remove it outwards to the rear.
Installation:
Correctly hook entrance cover strip (1) into liner for lower door column (3) with retaining tabs (4).
Installation:
Replace faulty clips (1).
Replacement
Modify clips (1).