34 33 071 Replacing vacuum hose for brake booster (N63)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Before beginning work, fully press the brake pedal several times to reduce the vacuum pressure in the brake servo. This makes it easier to remove the vacuum hose.
Vacuum hose and non-return valve are welded together and are replaced together as a single unit.

Necessary preliminary tasks:

Read and comply with General Information.
Remove partition wall, units compartment

Pull off partition wall seal upper part (1) in direction of arrow.

Remove non-return valve (2) from brake servo.

Fig 1: Removing Non-Return Valve From Brake Servo

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check gasket for non-return valve and replace if necessary.

Unclip vacuum line (1) from line clip (2).

Unlock snap fastener (3) and detach vacuum line.

Fig 2: Identifying Vacuum Line, Line Clip And Snap Fastener

Courtesy of BMW OF NORTH AMERICA, INC.