Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335xi, and 2010 BMW 335i. However, it is still accessible from the selected car via links, so may be relevant.

Remove pedal TRIM .
If necessary, remove OVER-CENTRE HELPER SPRING

Disconnect return spring (1).

Press end of pin (2) together with offset pliers and press out pin.

Detach locking clip (3) and pull clutch pedal off bearing block.

Installation:

Replace locking clip (3).

Locking clip (3) must be seated with both legs in the pin groove.

Fig 1: Identifying Return Spring, Pin, Locking Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check bearing bushings (1) and replace if necessary.

Lightly grease bearing bushings (1).

Fig 2: Identifying Bearing Bushings

Courtesy of BMW OF NORTH AMERICA, INC.