LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2007 >> 335i 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1245 (Engine Electrical System - Repair - E90 (N51)) >> 1242 Starter Lead >> 1242500 Replacing battery positive lead (between starter, alternator and battery positive terminal) >> Necessary preliminary tasks

Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 328xi, 2010 BMW 328i, and 2009 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Remove protective cap (not shown).

Unfasten nut.

Tightening torque 12 42 1AZ .

Remove battery positive lead (1) from battery positive terminal.

Fig 1: Identifying Battery Positive Lead On Battery Positive Terminal
G04751340Courtesy of BMW OF NORTH AMERICA, INC.

Release nut and remove battery positive lead (1) from alternator.

Tightening torque 12 31 1AZ .

Fig 2: Locating Battery Positive Lead Nut
G04751341Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug (1) and remove.

Unfasten nut.

Tightening torque 12 41 3AZ .

Detach battery positive lead (2) from starter motor and remove.

Fig 3: Identifying Plug And Battery Positive Lead
G04751335Courtesy of BMW OF NORTH AMERICA, INC.
NOTE: Check stored fault messages.
Delete fault memory.
scientia non olet · About LEMON Manuals